Floral Skull 16 oz - Halloween UVDTF Cup Wrap (CNWFH5)
Floral Skull 16 oz - Halloween UVDTF Cup Wrap (CNWFH5)
Couldn't load pickup availability
This wrap is perfect for your next DIY project or will make the perfect addition to your Halloween collection or bundle. Simply peel and stick for a premium and stylish look on glasses, tumblers, and more!
No heat or weeding needed, just peel, stick, rub, and peel! Say goodbye to tedious weeding and layering vinyl, and hello to effortless designs! Order now!
Be sure to tag @cut3nahnotes in all your cute creations, I’d love to see what you create!
Note that all brands of 16 oz. glass cups may not have the same measurements. They may differ by a couple of millimeters. Our wraps have been measured to fit Libbey glass cans. Please make any necessary adjustments during your application process. We are not responsible for your application errors or mishaps.
Please be aware that due to the differences in monitor and device settings (brightness, contrast, saturation, etc) there may be a slight difference in color between what is shown on the site and the final product.
🖤Follow us on Instagram and TikTok @cut3nahnotes for all the behind the scenes shenanigans.
Be sure to tag @cut3nahnotes in all your cute creations, I’d love to see what you create!
Materials
Materials
• A single UVDTF transfer.
- No cup included!
Dimensions
Dimensions
9.45 X 4.3
Care
Care
Application Instructions
- Hand wash cup cup with soap and water to rid it of oil and debris.
- Although not recommended if you choose to use alcohol, follow it up by wiping it down with a microfiber cloth and let air dry for two (2) minutes.
- Avoid touching the glass where the wrap or decal will go. If so repeat the above steps prior to application!
- Measure cup with cup wrap
- Trim any excess from the sides.
- Peel the backing from the transfer from one end slightly and fold down leaving the remainder of the backing on until lined up on cup.
- Line wrap onto one side of cup and press it down.
- While pressing the transfer down, turn or twist the cup.
- Rub the transfer well with your fingers or squeegee and then with lots of pressure using a squeegee to remove any bubbles which will allow proper adhesion
- If you still have bubbles you can try poking them with a small pin, but not on the design!
- Peel off clear film slowly to make sure all the graphics have adhered to the glass or surface. Pay close attention to this with smaller graphics.
